AVOCOR AVF-6500 Series, Руководство по установке и эксплуатации

Страница: 50 / 84

50
IRFM:
Select IRFM from the Advanced Settings menu and press
◄ or ► to enable or disable this
feature, which creates slight frame motion to help avoid image retention.
Baud Rate:
Select Baud Rate from the Advanced Settings menu and press ◄ or ► to set the data rate of the
RS-232 communication link.
Smart Light Control:
Select Smart Light Control from the Advanced Settings menu and press or to configure the
automatic backlight control feature of the display. Select one of the following, or select Off to
control the backlight level manually with the Backlight control in the Video Settings menu.
• Light Sensor: With this setting, the backlight level is controlled by the display’s internal
ambient light sensor.
•
DCR: With this setting, the display automatically adjusts the backlight level according to
the amount of contrast and brightness in the source material.
Wake Up From Sleep:
Select Wake Up From Sleep from the Advanced Settings menu and press
◄ or ► to control this
feature, which operates as follows:
• VGA Only: The display normally wakes up from power-saving mode when it receives an
active video signal on its VGA (analog) input.
• VGA, Digital, RS232: The display wakes up when it receives an active signal from its VGA,
HDMI or DisplayPort inputs, or receives a valid RS-232 command.
• Never Sleep: The display never enters power-saving mode.
Ethernet Setup:
Select Ethernet Setup from the Advanced Settings menu and press
► to configure the display’s
network settings.
• Enable Network: Enables the network feature. Option: No, Yes.
• IP Address Settings: When network feature is enabled, press
► to configure the following
IP addresses:

Dynamic IP: Enable DHCP for dynamic IP address assignment.

Static IP Address: Sets the static IP address when the DYNAMIC IP line is disabled or
views it when the DYNAMIC IP line is enabled.
Range: 255.255.255.255 (0.0.0.0)