Avocent LongView LongView Wireless, Инструкция по установке и эксплуатации

Страница: 21 / 32

Chapter 3: Operations
11
Main menu options
The LongView Wireless extender Main menu has two options - Auto Setup and Mode. When the
Auto Setup button is selected, the video parameters of the source server are checked and then the
receiver automatically optimizes the video quality portrayed on the receiver monitor. Selecting the
Mode button allows additional control of display optimization. The two modes available are
Computer or DVD. Selecting the Change button toggles between these two modes. If DVD or
video is being displayed, the DVD mode should be selected.
Advanced menu options
The LongView Wireless extender OSD Advanced menu allows you to fine-tune the video settings
that were established with the Auto Setup function. You may tune the horizontal and vertical
position of the video monitor window, as well as adjust the brightness and contrast of the video
image. You may also adjust the video clock phase in the LongView Wireless transmitter relative to
the video clock at your source server to assure the cleanest, sharpest video image.
Image adjustment using the LongView Wireless extender OSD
When configuring the OSD, you may use the Auto Setup function to automatically optimize the
video of your LongView Wireless extender or you may choose to optimize the video of your
LongView Wireless extender manually. When optimizing video, best results can be obtained by
displaying a fixed image on screen during the optimization process.
To optimize video automatically:
1. Activate the OSD Main menu on the receiver device by pressing and holding the left
Shift
key
followed by the right Shift key and then releasing both. You may also activate the OSD via the
mouse by right-clicking twice and left-clicking once in rapid succession.
2. Optimize the video setup of your LongView Wireless extender by selecting Auto Setup - Run .
This will automatically optimize your video setup parameters.
3. Select Finish at the bottom of the Main OSD menu to save the mode and current dynamic Auto
Setup settings.
- or -
If you wish to exit without permanently saving changes, select the
Cancel button. The OSD
parameters will remain in effect until the device is powered down or a change in resolution is
detected (if dynamic Auto Setup is on).
To optimize video manually:
If your monitor image requires further adjustment after running the Auto Setup, you may use the
Advanced Setup options from the LongView Wireless extender OSD menu.
1. Activate the OSD Main menu on the receiver device by pressing and holding the left Shift key
followed by the right
Shift
key and then releasing both. You may also activate the OSD via the
mouse by right-clicking twice and left-clicking once in rapid succession.
2. Select the Advanced tab from the OSD Main menu.
383C-LongviewWireless.book Page 11 Wednesday, April 13, 2005 9:30 AM