Avocent CPS1610, Инструкция по установке и эксплуатации

Страница: 47 / 82

47
RESUME Command
RESUME (no parameters)
Rights Required: none
To resume your connection to the attached serial device, enter the RESUME
command. You will then exit the CLI and reconnect to the attached serial
device. If any data was received while you were in command mode, it is
contained in the history buffer.
SERVER Command
The SERVER command is used to make changes to the CPS and network
settings in the CPS Configuration Database. It is also used to update the CPS
program image in FLASH memory and to reboot the CPS.
Changing CPS Settings
SERVER SET IP=ip-address
MASK=subnet-mask
GATEWAY =gateway-ip-address
ip-address is the IP address to be assigned to the CPS.
subnet-mask is the subnet mask for the subnet on which the
CPS resides.
gateway-ip-address is the IP address of a default gateway to be
used to route IP packets.
Rights Required: SCON
To change the CPS IP address and network subnet, use the SERVER SET com-
mand. The IP and MASK keyword parameters are required. The GATEWAY
keyword parameter is not required, but is needed if the CPS is to be accessed by
subnets other than the one on which it resides.
The ip-address, subnet-mask and optional gateway-ip-address should be speci-
fied using standard dot notation.
Upon successful completion of this command, the parameter values will be
changed in the configuration database, but will not become effective until the
next time the CPS is rebooted.