Avocent CPS1610, Инструкция по установке и эксплуатации

Страница: 20 / 82

20
CPS 810/1610 Installer/User Guide
The username for initial login is Admin. There is no password for the Admin
user. At the password prompt, press
Return .
Avocent CPS1610 S/W Version 1.12 (ASCII)
Username: Admin
Password:
Authentication Complete
CPS configuration is required.
Once authentication is completed, the CPS will prompt you for any missing
CPS configuration values needed for correct operation. These values are:
CPS IP address
CPS network subnet mask
Admin password
If you have already provided the IP address and subnet mask information,
you will not be prompted for it again. These values may already have been
assigned by vConsole or by BOOTP. Enter the missing configuration values,
referring to the applicable directions below.
Enter the IP address for the CPS using standard dot notation.
CPS configuration is required
Enter CPS IP address > 192.168.0.5
Enter the network subnet mask for the CPS using standard dot notation.
Enter CPS Subnet Mask > 255.255.255.0
Enter the Admin password. Passwords are case sensitive and must be from
three to sixteen characters in length. You must enter the Admin password
twice to confirm that it has been entered correctly.
Enter CPS New Admin Password > *****
Confirm New Admin Password > *****
Once you have completed the necessary configuration values, the following
message will appear while the CPS stores the values in its database.
Configuration is being stored. Please wait.
IP Address 192.168.0.5 with subnet mask 255.255.255.0 has been set
New Admin password has been set
>
Initial login is now completed and the command line interface is available for
use. Refer to Chapter 2,
Configuring Serial Port Settings for an introduction
to the CPS Command Line Interface. Chapter 4, The CPS Command Line
Reference contains detailed information on the CPS command language.