Avnet Telus LTE-M IoT Starter Kit, Руководство пользователя по оборудованию

Страница: 16 / 25

Page 16
12 The Telus LTE-M IoT Starter Kit
Assembly and deployment of the Starter Kit requires just three steps:
12.1 Assemble the Board Stack
Stack the three boards together as shown below using their Arduino connectors:
Top : Avnet Quectel BG96 Shield
Middle : X-NUCLEO-IKS01A2 Sensor Expansion board
Bottom : NUCLEO-L496ZG Microcontroller Board
Figure 11
– Board Stack-Up Detail
12.2 Connect the LTE and GPS Antennas
Attach the LTE antenna (FXUB63) to the SMA connector next to the USB connector on the BG96 board.
Attach the GPS antenna (FXP611) to the SMA connector next to the PWRKEY switch on the BG96 board.
Tighten by finger both of the SMA retaining nuts
12.3 Connect the USB Cable
Apply power by connecting the provided microUSB cable from NUCLEO-L476 board, to the Computer.
The USB ST-Link and UART interfaces should enumerate (no need to press S1 switch)