MSC Q7-MB-EP6
User Manual
35 / 35
3.23
Vendor Specific Signals MFG_NC3 and MFG_NC4 (J701,
J702)
The EP6 carrier board provides these 2 signals on jumpers for boot loader implementation
and firmware development.
J702 pins
Fan Power
1-2 (default)
MFG_NC3 high, 10k pull-up to +3,3V
2-3
MFG_NC3 low, GND
Table 36
Jumper J702
J701 pins
Fan Power
1-2 (default)
MFG_NC4 high, 10k pull-up to +3,3V
2-3
MFG_NC4 low, GND
Table 37
Jumper J701
3.24
Fan Connector and Configuration (X907, J901)
The EP6 carrier board provides the ability to connect a 5V or 12V 4 Pins Cooling Fan. The
following tables describe the pin out and jumper configuration possibilities.
References:
Type:
Molex 53261-0471
Mating:
Molex 51021-0400
Pin Signal
Function
1
FANPWM
(output)
PWM signal to control fan speed
2
FANTACHO
(input)
Signal to measure fan speed
3
FANPOWER
Fan power +12V or +5V
4
GND
Ground
Table 38
Pinout Fan Connector X907
J901 pins
Fan Power
1-2 (default)
12V (from +12V regulator, 15V < Vin < 28V)
2-3
5V
Table 39
Jumper J901 for Fan Power
3.25
Power LEDs (LED1101, LED1102)
There are two power status LEDs on the EP6 board.
The LED1101 indicates the presence of 5V power on the EP6 board. This LED is off when
the system goes in the sleep mode. A light pipe is used to bring the light on to the front
panel.
The LED1102 ind5V standby. As soon as the internal 5V regulator starts working,
this 5V LED1102 remains on.