A V L L O O M S
AVL Looms, Incorporated
2360 Park Avenue, Chico, California 95928-8305
Phone: 530-893-4915 Fax: 530-893-1372 www.avlusa.com
Revision 4/9/14
7
Mounting Block, with one (1) 1/4" Washer and one (1) 1/4" Nylock. Stretch the #8350
Spring from the Eye Bolt to the Eye Hook centered on the facing side of the Spring
Lever.
1
1/4-20 x 2-5/8
Eye Bolt
1
1/4-20
Hex Nut
2
1/4"
Washers
1
1/4"
Nylock
1
8350
Spring
3)
Remove the Original Cam-Pulley Assembly
– Loosen the right-hand stop collar
located on the Cam-Pulley Axle on your loom. Pulling to your left, withdraw the axle
and remove the Cam-Pulley Assembly and Left Treadle Pulley.
Disconnect the Dobby Arm/Cylinder Cable from the Cylinder, leaving it attached
to the Dobby Arm. Use a sley hook to reach into the side hole and pull out the retainer,
allowing the Cable to slip free of the Cylinder.
4)
Replace Cam-Pulley Axle
– (see Figure 6) Attach the Dobby Arm Cable to the new
Cylinder, using the retainer to hold the Nico tip in place on the new Cylinder. Starting
from your left, insert the Axle through Leg “A” so the end extends a few inches into the
middle space between Legs “A” and “B”. As seen in Figure 4 and in this order, slide the
following components onto the Axle:
a.
1
1/2" Stop Collar
b.
1
Cam/Cylinder Assembly
c.
2
1/2" Stop Collars
d.
1
Left Treadle Pulley
e.
1
1/2" Stop Collar
Then slide the Axle through Leg “B” and replace the right-hand Stop Collars on the end
of the Axle.