A V L L O O M S
AVL Looms, Incorporated
2360 Park Avenue, Chico, California 95928-8305
Phone: 530-893-4915 Fax: 530-893-1372 www.avlusa.com
Revision 4/9/14
6
4
5/16-18 x 2”
Hex Bolts
4
5/16
Split Lock Washers
4
5/16
Square Nuts
Figure 5 – Motor Box Installed
INSTALLING THE E-LIFT II+
1)
Install the E-Lift II+ Motor Box -
(see Figure 5) Position the Box underneath and
between the two Crossmembers.
Insert the four (4) 5/16-18 x 2-3/4” Hex Bolts, with
washers, from the outside, into the previously drilled Holes #2 and #3, just far enough to
keep them from falling out, while not protruding into the central area. Position the Box
in the space between the Crossmembers, so that the Plug Connection for the Pedal faces
to the Front and the Motor Box Pulley is closest to the Left Side of the loom. Lift the
Box into place and push the Mounting Block Bolts all the way through the Blocks and
tighten in place with one (1) 5/16 Washer and one (1) 5/16 Nylock on each Bolt.
4
5/16-18 x 2-3/4”
Hex Bolts
8
5/16
Washers
4
5/16
Nylock
2)
Mount the Spring Assembly
– (see Figure 4) On the inside of the loom, into the hole
located in the mid-section of the rear Mounting Block, insert the 1/4-20 x 2-5/8 Eye Bolt,
with one (1) 1/4-20 Hex Nut and one (1) 1/4" Washer. Secure it, on the outside of the