AVL Looms Jacq3G, Руководство пользователя

Страница: 96 / 176

Install the Beater Jacq3G Loom User’s Manual
Page | 88 Vertical Pull Flystring Tie-Up
V
ERTICAL
P
ULL
F
LYSTRING
T
IE
-U
P
The flystring tie-up cord should come with the handle already attached in the
middle. You will route the flyshuttle cord from the middle of the loom to one
side, then do the other side.
Attach the Flyshuttle handle
If the flyshuttle handle is not attached to the cord already, follow these
instructions to attach it.
1) Locate the flyshuttle handle. It is a small, dark colored piece of
wood with a hole and a brass pin through the center of it.
2) Form a tight loop at the center of the cord.
3) Feed the loop down from the top of the handle through the hole on
either side of the brass pin that divides the hole.
4) Now feed the loop back through the hole on the other side of the
brass pin. Form a larger loop (6” or so) and put the handle through
this loop. Bring the string of the loop all the way back up to the top
of the handle.
Figure 73 - Flyshuttle on cord
5) Pull straight down on the handle, tightening the cord around the
brass pin. This procedure should automatically center the handle on
the tie up.
6) You will tie an overhead knot in the cord between the two upper
pulleys. Tie a simple overhand knot with the handle already in
place.