AVL Looms Jacq3G, Руководство пользователя

Страница: 167 / 176

Jacq3G Loom User’s Manual Troubleshooting
Equipment Fixes Page | 159
Reinstall the Module Hook
1) With the plunger and new spring pinched in place on the hook,
approach the Upper Guide from underneath and reinsert the Upper
Hook into its correct space in the Upper Guide. Be sure the Upper
Hook is facing the same direction as the other Upper Hooks. Once
the hook is clear of the Upper Guide, find the little hole in the
Solenoid and gently press the plunger, with the newly mounted
spring, into the hole. Use a finger on one hand to apply slight
pressure to the plunger in order to keep the Plunger/Spring in
place, until the hook has been stabilized in the Middle Guide.
2) With the other hand, move the hook up until the bottom of the
hook has cleared the Middle Guide.
3) Lower the hook through its space in the Middle Guide.
4) You can now release your hold on the plunger and continue the
downward movement until the hook can be dropped into the space
on the Lower Guide and the Lower Hook will rest on the Lower Slide
Bar.
5) Reconnect the hook to the heddle with the small, black clip, taking
care to avoid any twisting in the hook or entanglement with
adjacent hooks, heddles, or springs.
To Remove/Replace A Module Hook
No special tools are required.
To Remove the Module Hook
1) Be sure the loom is turned off. It is recommended that, either the
apron or some large paper (i.e., newspaper), be spread under the
loom to catch any plungers (small) or springs (very small) that may
fall during this procedure.
2) Unhook the small, black connection hook between the Module hook
and the heddle.
3) Gently lift the hook vertically, until the bottom of the hook has
cleared both Lower and Middle Guides, but is still engaged in the
Top Guide. Avoid entanglement with neighboring hooks or bending
by keeping the hook in vertical alignment with adjacent hooks.