4.
The IP disconnection indicator will initially show on the panel indicating no
connection.
IP1- John IP 2 – Mary IP3- Tom
IP4- Mike IP 5 – Paul IP6- Bill
IP7- Tim
IP disconnection indicator
NOTE:
It normally takes about four seconds for each IP to make the connection. The
network bandwidth will affect the connection speed and quality.
5.
The panel will be ready to use when the IP disconnection indicator
disappears from the screen.
NOTE:
Make sure all slave modules have the same baud rate as the master module to
allow the Z commands to be passed from the master module to the slave modules (refers to
Avitech modules that are cascaded with the master module and also accepts Z commands
passed by the master modules) over a RS-485 cascade cable.
3.3
ACP Run-Time
The ACP Run-Time feature allows the PC to function as a TACP. This allows
the PC to perform module communication without the need to pass the
configuration information through the TACP by performing the following steps:
Set up the configuration
1.
On the
IP Table Editor
window, assign a name for your ACP and set the PC’s
IP address as the TACP’s IP address.
2.
Create new button(s) and edit the page layout (see Chapter 2 for details).
55
