Avital AviStart 6000, Руководство по установке

Страница: 11 / 28

Reverse Light
I CAUTION: Some vehicles allow you to remove the gear shift
selector from "Park" even while the ignition key is not on. As a safety
feature, the system will monitor the reverse wire. If the vehicle is
removed from "Park" while in the remote start mode, the system will
shut down immediately.
1. Set the parking brake.
2. Turn the ignition key to the "ON" position and adjust the gear shift selector
to "Reverse."
3. Use a voltmeter to find the wire that will show +12 volts in "Reverse" and
0 volts in "Park."
4. Connect the YELLOW/BLACK wire to the vehicle’s reverse light wire.
Interior Light Illumination
1. Connect the WHITE wire to the vehicle door trigger wire.
2. If the door trigger is negative, connect the WHITE/BLACK wire to ground.
3. If the door trigger wire is positive switching, connect the WHITE/BLACK
wire to a fused constant +12 volt source.
Channel 2 Accessory Output (Trunk Release)
The DARK BLUE wire provides a 0.75 second ground output when the
TRUNK button is pressed for 1-2 seconds. If the TRUNK button is continually
pressed, the output will stay at ground as long as the button is held. Most
factory trunk releases are positive trigger and require an optional relay.
Channel 5 Accessory Output
The LIGHT BLUE wire provides a 0.75 second ground output when the
ARM/DISARM and SILENT buttons are pressed at the same time for 1-2
seconds. If the ARM/DISARM and SILENT buttons are continually pressed, the
output will stay at ground as long as the buttons are held. This output can be
used for optional accessories such as window roll-up/down or any other
accessory requiring a (-) input.
9
AviStart 6000 Installation Manual