Avital Avistart 4001, Руководство по установке

Страница: 9 / 24

Reverse Light
I CAUTION: Some vehicles allow you to remove the gear shift
selector from "Park" even while the ignition key is not on. As a safety
feature, the system will monitor the reverse wire. If the vehicle is
removed from "Park" while in the remote start mode, the system will
shut down immediately.
1. Set the parking brake.
2. Turn the ignition key to the "ON" position and adjust the gear shift selector
to "Reverse."
3. Use a voltmeter to find the wire that will show +12 volts in "Reverse" and
0 volts in "Park."
4. Connect the YELLOW/BLACK wire to the vehicle’s reverse light wire.
Interior Light Illumination Output
1. Connect the alarm WHITE/BLACK wire to relay terminal 85.
2. Connect relay terminal 86 to a fused co12 volt source.
3. Connect relay terminal 30 to the vehicle door trigger wire(s).
4. If the vehicle door trigger is positive (+) trigger, connect relay terminal 87
to a fused +12 volt source.
5. If the vehicle door trigger is negative (-) trigger, connect relay terminal 87
to ground (-).
Trunk Release
The DARK BLUE wire provides a 0.75 second ground output when the d
button is pressed for 1-2 seconds. If the d button is continually pressed, the
output will stay at ground as long as the button is held. Most factory trunk
releases are positive trigger and require an optional relay.
Remote Start Armed Signal (-) Output
The GRAY/BLACK wire will provide a continual ground output for as long as
the vehicle is in the remote start mode. This output can be used for additional
ignition, starter or heater/AC relays.
7
AviStart 4001 Installation Manual