Avital Avistart 4001, Руководство по установке

Страница: 10 / 24

Remote Panic Capability
The VIOLET wire will provide (-) output when the
C
button is pressed for 3-4
seconds. The (-) output can be programmed for a continual output when
adding an optional siren or a pulsed output when tapping into the vehicle (-)
horn wire. See the "Programming Table for System Features" on page 20.
Factory Alarm Disarm (-) Output
The GRAY/WHITE wire will provide a 0.75 second ground output when the
s
button is pressed.
1. Arm the vehicle factory alarm system.
2. Use a volt/ohmmeter to locate the one wire that will show ground only
when the driver door key cylinder is held in the unlock position.
NOTE: Most factory alarm/disarm wires will show 8-12 volts while
armed. A few vehicle disarm wires will rest at a neutral state while
armed. Regardless of type, both types will change to ground when the
key cylinder is turned to unlock.
3. Connect the GRAY/WHITE wire to the factory alarm disarm wire.
Factory Alarm Rearm
There are two types of factory alarm systems that the AviStart can rearm.
System #1
This type of system has a designated alarm
arm wire that requires a (-) pulse to arm the
alarm.
1. Use a volt/ohmmeter to find the factory
arm wire that will show (-) ground
while the driver door key cylinder is
turned to the "LOCK" position. If you
are interfacing with the vehicle power
door locks, use the diagram at right. If
not, proceed to step #2.
2. If you are not interfacing with the vehicle power door locks, connect the
AviStart BLUE/WHITE wire to the vehicle arm wire. The BLUE/WHITE wire
will provide a single 2-second (-) output five seconds after the engine is shut
off with the remote control or timed out. (Some vehicles may require 2
pulses. See "Programmming Table for System Features" on page 19.)
8
AviStart 4001 Installation Manual