Avital Avistart 4001, Руководство по установке

Страница: 11 / 24

System #2
This type of system does not have a designated "arm" wire. To arm the alarm,
you must lock the doors while the interior lights are on.
1. Simply connect to the interior lights and door locks as indicated in the
manual.
Glow Plug Light Monitoring
The glow plug light (+) input wire will monitor the glow plug light in the
dashboard. When a remote start is attempted, the ignition will turn on and
when the glow plug light turns "OFF" the engine will start
1. Locate the glow plug light wire that will show (+) 12 volts while the
ignition key is on and the glow plug light wire is illuminated.
2. Connect the AviStart ORANGE/BLACK wire to the vehicle glow plug
might wire.
NOTE: Do not use both "pre-ignition" and "glow plug light monitoring" at
the same time (use one or the other).
Ignition Switch Connections
NOTE: Because these wires can draw high current, we recommend that they
be soldered and shrink tubed or taped.
Ignition
Most vehicles have only one ignition wire. If an additional ignition wire is
required to remote start the vehicle, a 30/40 amp relay must be added. Do not
use the PINK wire to power more than one ignition wire.
1. Use a voltmeter to locate the wire(s) that show +12 volts while the ignition
key is in the "ON," "CRANK" and "RUN" positions and 0 volts when the
ignition key is in the "OFF" position.
2. Connect the PINK wire to the vehicle ignition wire.
9
AviStart 4001 Installation Manual