7
Press
【
ENTER
】
to confirm the selected baud rate. There will be a 1-sec beep sound once the setup is complete.
Press
【
ESC
】
3 times to exit the setup mode and return to normal working mode.
Note:
if all the devices/ cameras are to be set to the same protocol and baud rate, please follow the steps as follows:
Enter the setup page
and choose the corresponding protocol and baud rate.
Press
【
ENTER
】
to confirm. All the devices with an address of 0-255 will be set to the same protocol and baud rate.
5.2 System setup
System setup includes:
-
Change password
-
Restore factory setting
-
Indicate sound switch setting
-
Keyboard ID
-
Keyboard lock switch setting
5.2.1 Password setting
Press and hold
【
SETUP
】
for 3 seconds (under normal working mode), then follow the steps below:
Press
【
2
】【
8
】
Press
【
Enter
】
Move joystick downward to choose the
right protocol: Pelco-P
Move joystick rightward to
choose the right baudrate: 9600
Move joystick downward
【
Enter
】
【
Enter
】
Input the original password then press
【
Enter
】
Input new password (4 digits), press
【
Enter
】
Input password then
【
Enter
】
