17
9.
This twin motor powered KingTwin
uses
a set of counter-rotating propellers, and they spin
inwards when view from the front.
PROPELLER AND SPINNER INSTALLATION
10. Find a propeller with a marking “L” on the prop hub which will be installed on the left-hand side. It
spins clockwise when view
ed
from the front. See pic shown below.
Place the prop on the spinner back plate. Install the assembly, and at the same time, install the
spinner onto the motor shaft, and hand tightened it until the whole assembly is fully seated on the
drive hub. Repeat the above steps on the right hand side.
Note: Don’t over tighten
it as this will deform, and overly stress the plastic spinner and it
may cause parts breakage in flight, and even loss of control.
1
2
3
4