Avid Technology NEXIS File Gateway, Руководство по установке и эксплуатации, Страница: 20 / 57

Keyboard, Monitor, and Mouse Connections
20
To secure the server to the rack enclosure:
1. Lift and position the server so that the inner slide rails (secured to the File Gateway server) are
aligned with the outer slide rails secured to the rack.
2. Push the front of the File Gateway server flush against the front mounting rail. The holes in the
server front panel align with the holes in the front mounting rail.
3. From the front of the rack enclosure, insert the large Phillips-head screw through the File
Gateway server and front mounting rail.
- Square hole racks — Use the middle hole of the outer rail kit to secure the server front panel
to the vertical rail. An M6x10 screw is included in the parts kit to secure the front panel.
- Round hole racks — Attach the server front panel to the vertical rail of the rack. Use a truss
head screw or hardware that comes with your rack to secure the front panel.
Front Panel Screws
Keyboard, Monitor, and Mouse Connections
Use an industry standard USB keyboard, USB mouse and VGA monitor to access the File Gateway
server. You can optionally use a KVM switch if several servers are installed in the rack. The
keyboard, monitor, and mouse connections use the ports described in the following procedure.
Follow the instructions supplied with your KVM switch. You must supply KVM cables that are
compatible with your KVM switch.
n
There are only two USB ports on the rear of the File Gateway server. One of the ports is typically
used for the application key. When you purchase your KVM switch make sure it includes a USB
splitter cable so that both your keyboard and mouse can plug into the splitter cable and use a single
USB port on the server.
The following figure shows the rear panel of the File Gateway server and the connections used
during the setup.
Rack enclosure
front mounting rail