Avid Technology Milan MLN-192, Руководство по установке

Страница: 11 / 16

MLN-192 Option Card Installation 11
5
Lift the tab on the retaining clip, and then apply pressure along
the entire edge of the card to press it firmly into the PCIe port
and clip.
6
Tighten the exterior captive thumbscrew to secure the face-
plate of the Network card to the E6L.
7
Tighten the rear bracket captive thumbscrew to secure the
back of the card to the chassis.
8
Connect the Ethernet jumper cable from the middle port on the
lower Master AVB-192 card to the middle port on the upper
AVB-192 card.
9
If you reinstalled a WSG-HD card in slot 6, make sure to re-
connect the Ethernet jumper cable from the left-most Ethernet
port on the Master AVB card to the left-most port on the
WSG-HD card.
Figure 46. Lifting the tab on the retaining clip
Figure 47. The Network card PCIe connector properly seated in the
PCIe slot
Figure 48. Tightening the exterior thumbscrew
Figure 49. Tightening the rear bracket thumbscrew
Make sure all cards are secured to the back bracket.
Figure 50. Ethernet cable connected between cards (E6L-192 or
E6L-144 only)
Unlike AVB-192 and WSG-HD cards, no internal Ethernet
jumper cables are required for the MLN-192 card.