AVIATION DESIGN
- ZI le Chenet - 91490 MILLY LA FORET – FRANCE - Tel : int+ 33 1 64 98 93 93 - [email protected] – www.adjets.com
2
INTRODUCTION
The Falcon 7X from
AVIATION DESIGN
is a very large model designed for a single high thrust and light
turbine.
It is fully molded in fiberglass, carbon and epoxy.
All plywood reinforcements are already glued.
The flight characteristics are excellent with very good low speed capability.
The model has plug in wings and stabs.
The Falcon 7 X will operate from prepared grass fields (250 meters long) or tarmac surfaces (150 m).
KIT FEATURES: ref ADJ 500
- High quality, white gel-coated epoxy-
glass fuselage. The fuselage is in two
parts for ease of handling and
transportation.
- Nose cone and door for radio access
molded in carbon epoxy
- 1 Epoxy-glass inlet ducting
- Fully molded epoxy carbon wings
with tube for aluminum spar and gear
support already glued.
- Fully molded epoxy carbon stabs with
tube already glued
- 2 Winglets
- 2 engine nacelles
- Carbon gear doors
- 2 carbon stab spars
- 2 aluminum wing and engine tubes
- All clear canopy CNC cut.
- Foam floor CNC cut.
- All hardware (screws, servo cover,)
- Instructions in English.
Parts required to complete the kit:
Turbine:
One Jet Cat P160 SE turbine or any light 16 kg thrust turbine.
Turbine must be as slight as possible to reduce CG problem
Kevlar Fuel tanks: ref ADJ 640 KU
Two Fuel cells molded in Kevlar with a 4.2L capacity
Includes tubing, nipples and 1 hopper tank
Can be used if you fit the interior in the fuselage. Two Fuel tanks fit under the floor
Kevlar Fuel tanks: ref ADJ 641 KU
One Fuel cell molded in Kevlar. Capacity: 4.2 liters
Includes tubing, nipples and 1 hopper tank
Can be used if you do not fit the interior in the fuselage. Fuel tank fits in the middle of the fuselage
