AVG-CS4K-44
Note: Send command “%0901.” to enter infrared carrier enforcing mode if the IR
Receiver connected to IR IN of the receiver does not have an IR carrier.
Multiple to Multiple: (IR Matrix)
The 4 “IR OUT” ports and the 3 “IR IN” ports on the far-end receivers make up a
4x3 IR matrix. See as below:
IR Matrix
The IR signal is sent by an IR remote, then it is input to the HDBaseT receiver, then
to the corresponding zone of the matrix through the twisted pair, finally it is
transferred to the IR OUT port and received by the appropriate source device.
Switching Operation
:
Sending command (reference to
5.2 RS232 Control)
: [x1]R[x2].
x1: Corresponding to the 4 IR OUT ports of the Matrix Switcher, the IR
transmitter connected to this port can be placed at the IR receiving area of
output device or the Matrix Switcher itself.
x2: Corresponding to the zone (receive IR signal from HDBaseT receiver with IR
IN port, connects with IR receiver) number of the Matrix Switcher.
→ Example: Send command “3R2.” to transfer IR signal received from zone 2 to
IR OUT port 3.
