Avery Dennison Monarch Tabletop Printer 1, Руководство системного администратора

Страница: 45 / 94

Setting Defaults 6-7
A d j u s t i n g t h e I m a g e L e n g t h
Using this setting requires continuous (non-indexed) supply. The printer ignores this
setting (does not error) when using other supply types.
This setting increases or decreases the image length based on the percentage entered.
Values are in tenths of a percent.
Note: If a print image is defined close to the label’s edge and adjust image length is set
to a negative value , the printed image may not be complete. Some of the image
may be lost. Verify your printed image is complete.
Examples
Format A is 10.0 inches long (as defined in the format header).
Image Length is +20
Format A prints 10.20 inches long.
Format B is 6 inches long (as defined in the format header).
Image Length is -30
Format B prints 5.82 inches long.
Note: Refer to the Packet Reference Manual for more information about defining the
format header.
Select To

Decrease the setting. Reduces the image length by the entered
percentage.

Increase the setting. Increases the image length by the entered
percentage.
Note: Press the left function button to change the amount (by 1 or 10).
S e t t i n g t h e S l e e p D e l a y
When the printer is idle for a selected period of time, it goes into sleep mode to conserve
power. Adjust the sleep delay setting from 1 minute to 240 minutes. The default setting is
60 minutes.
The printer wakes from sleep mode when it receives a print job, a button is
pressed, or the printhead is opened/closed.
Select To

Decrease the inactivity time before the printer goes into sleep mode.

Increase the inactivity time before the printer goes into sleep mode.
Note: Press the left function button to change the amount (by 1, 10, or 100).