Avery Dennison Mobile Work Station (MWS) Monarch 9876, Руководство по эксплуатации

Страница: 9 / 20

Charging the Batteries 2-1
C H A R G I N G T H E B AT T E R I E S
The battery charger is a fully automatic, maintenance-free charger. Dispose of used
batteries according to the manufacturer’s instructions.
CAUTION: The charger's power switch does not control MW S power. The MW S power switch,
located on the power panel, controls power to the MW S and connected devices.
To charge the battery, plug the MW S’s AC power cord into a grounded outlet.
Charge the battery:
♦
before using the MWS for the first time (charge it for 7 hours)
♦
when the MW S beeps (see “Battery Life” for indications of low battery conditions)
♦
when the MW S is not in use.
You may be able to operate equipment connected to the MW S for up to four hours while the
cart is charging. However, use of MW S equipment results in slower charge rates.
For optimal performance, we recommend that you turn off all equipment and allow the MW S to
achieve a full charge before returning the MW S to use.
You cannot overcharge the battery. The battery charger is “intelligent”; it monitors the battery
condition and does not overcharge the lead acid battery. Battery life is extended by frequent
charging.
CAUTION: Only qualified service personnel may install or replace the two 12-volt
(55 or 75 amp-hours) sealed lead-acid non-venting batteries on the MW S.
If replacing batteries, you must use the same type of battery from the same manufacturer
(as the ones provided with the MWS).
Make sure the batteries are NRTL-recognized.
Also, BOTH batteries MUST be replaced at the same time to maintain capacity match.
I mp o r t an t B a t t e ry S af et y I n f o r m at i o n
♦
Never smoke or allow a spark or flame in vicinity of battery.
♦
Do not drop a metal tool on the battery. The resulting
spark or short-circuit on the battery of other electrical part
may cause an explosion.
♦
Remove personal metal items such as rings, bracelets,
necklaces, and watches when working with a lead-acid
battery. A lead-acid battery produces a short-circuit current
high enough to weld a ring to metal, causing a severe burn.
2