avertX HD90IR, Руководство пользователя

Страница: 11 / 37

31626AA 11
Connections
AvertX HD90 cameras use Power over Ethernet (PoE). The only
connection on the camera is the RJ45 Ethernet dongle located on the
rear of the camera. Connect one end of the Ethernet cable to the
dongle, and connect the other end to the recorder, or to a PoE switch.
AvertX recommends using Category 5 Ethernet cable to connect the
camera to your network. For the best transmission quality, the cable
length should not exceed 328 feet (100 meters).
Once you have connected the camera, check the status of the network
connection by looking at the link indicator and activity indicator LEDs. If
the LEDs are not lit check your network connection. The green link LED
indicates a network connection and the orange activity LED flashes to
indicate network activity.
Ceiling Installation
The HD90 can be installed directly on a wall or ceiling provided it has
enough strength to support the camera.
1. Remove the HD90 from packaging
2. Connect the Ethernet cable from ceiling or wall to the dongle on the
camera.
3. Affix the mounting bracket to the ceiling or wall with the three
supplied self-tapping screws.
4. Use the supplied hex wrench and a Phillips screwdriver to loosen
the hex bolt on the side of the bracket mount and the camera
housing to adjust the position of the camera.
Note
HD90 cameras are equipped with a seal inside the housing to
prevent moisture from entering. If you have any concerns
about moisture entering the housing or wall through the cable
egress , AvertX recommends sealing the opening at the wall
and at the base of the camera with silicone caulking.