37084AA
14
INSTALLING THE CAMERA
Note:
Before installing this camera, please refer to the Quick Start Guide included in the camera
box.
The camera can be installed directly onto the wall or ceiling. Be sure that the structure is strong enough to
support the camera.
Ceiling and Wall Installation
CAUTION:
Using the included mounting screws is required to maintain IP67 outdoor rating. Using
other screws or modifying the camera may allow water intrusion and void the warranty.
DO NOT DRILL HOLES OR ATTEMPT TO ENLARGE THE MOUNTING HOLES IN
THE BASE OF THE CAMERA.
Dome cameras are ideal for installation on a ceiling or soffit location. If you are installing the camera
on a wall, AvertX recommends using the camera specific wall mount available for purchase on
AvertX.com.
1. For outdoor installations, seal any holes in the wall or ceiling with silicone caulk to protect against
water intrusion.
2. Affix the base of the camera to the wall with the included screws and wall anchors. Do not over
tighten the mounting screws.
3. Loosen adjustment screws and adjust the camera to the desired angle. Re-tighten adjustment
screws being cautious not to over-tighten.
4. If surface mounting the cable, make sure the cable is routed through the cable notch on the side
of the camera.
5. Replace the dome cover. For proper dome alignment and seal, alternate tightening screws.
Tighten dome cover screws just enough so the bottom of cover is flush with the base for a good
seal.
Tip:
Use the AvertX Connect mobile app to view the camera while adjusting view.
Note:
AvertX recommends sealing the opening at the wall and at the base of the camera with
silicone caulking.
