Avermedia SA5104, Руководство пользователя

Страница: 67 / 152

61
blue frame on the preview screen of FaceFinder setup window. User can select multiple areas for
detection. To clear the selected area, right click the mouse button and drag the selected area to clear.
Or, click
Clear
to clear all selected areas.
Detection Sensitivity:
To set the sensitivity level of face detection. More higher is more easily to detect
the difference of the face.
Minimal Face Size Level:
To set the face detection of minimal size. The system will only detect the face
size is equal or greater than the minimal face size. User should see a green frame on the preview
screen of FaceFinder setup window.
Trigger Condition Setting:
Set the conditions of the face detection that is trigger by outside device such
as sensor, relay device.
-
Enable:
Mark to enable
Trigger Condition Setting
.
-
Start Message:
Set the sensor level that will trigger the face detection. The default is high.
-
Stop Message:
Set the sensor level that will reset the condition of face detection. The default is low.
-
Activate Device:
Set the activate level of relay device. When the face detects condition meets the
condition in
Activate Delay
, the relay will send out the signal and the system will send out the face
object log. The log can be viewed in Face Object Log.
-
Activate Delay:
Set the condition for activating relay device to send out the log to DVR system. Select
the time (second) and times (the number of face has been detected) from drag down list.
-
Reset Device Status after seconds:
Set the time period to reset activate device back to normal
status. It works only when the activate status is set to trigger.
After set up, click
Start Test
to test the configure result. When the system is detecting face, the red frame will
show up on the screen. The test result will display in Face log List windows as below figure shown: