AVer CL01, Руководство пользователя, Страница: 13 / 17

8
5.
Auto Standby ON
↑↑↑↑
6.
Itself IP
：
192.168.1.88:5000
7.
About Keyboard
System Settings
(continued)

Joystick sensitivity
Set the joystick sensitivity level
–
1
–7
. The higher the joystick sensitivity is set, the smaller the
movement necessary to produce rapid pan/tilt rotation.

Auto standby
Set the length of idle time before the PTZ camera controller enters standby mode
–
1 , 2 , 5 , 10 , 20 ,
30 , or 60 minutes.

IP address
Set up the PTZ camera controller
’s IP address and port. The default IP and port are
192.168.001.088: 5000.
[Tip] Use the number buttons (0
–9) to enter the IP address and port.

About
Displays the name of the PTZ camera controller, firmware version, and serial number.
COM Settings
The COM settings menu is as shown below:
1. Channel: CAM1
2. Address: 1
3. Baud rate: 9600
4. Protocol: Visca

Channel
Select the channel to set up. The channels correspond to the CAM1
–CAM7 buttons on the PTZ
camera controller.

Address
Set the channel address. The table below shows the available address values for different
protocols.
Wh
en the address is set to “Other,” you can modify the address by pressing the corresponding
channel button(s) after exiting the settings menu. For example, if the address for CAM1 is set to
“Other,” press “1” + “2” + “CAM1” to set the CAM1 address to 12.
Protocol Address value
Visca
1
1
–7
SonyVisca
2
1
–7, other
Pelco-P 1
–7, other
Pelco-D 1
–7, other
2:
Sony VISCA
(IP)
IP: VISCA over IP
1:
VISCA
(RS232)
Serial Port(RS232/422/485): VISCA
UDP VISCA