www.avenview.com
Page 6
Step 4
: Powering the Transmitter and Receiver Units
Connect the power cord/adapter into an available electrical outlet, and connect the power cord to the DC in port on
W-hDM3D-S-100 and Rx.
Optional Accessory: CW-HDMDVI-100 DC Splitter
An alternate power method for wireless RX or Tx units
Step 5
: Sync and Begin Wireless Transmission
Turn on power to the source, Tx, Rx, and destination. The green indicator light on each W-hDM3D-S-100 unit will flash as
syncing is taking place. When the green light is solid, the Tx and Rx have successfully paired and a signal should be transmitting.
To re-sync a connection between Tx and Rx, push and holding down the “Pinhole Switch” button for 4-5 seconds or until the
lED flashes.Be sure to select the appropriate DVI input mode on the destination display monitor.
There are times in the operating room when
finding enough power outlets is an issue. In order
to minimize the amount of power outlets used by
the W-hDM3D-S-100 pair, the DC Splitter option
can be used to draw power from the monitor cable
and send it to the W-hDM3D-S-100 receiver.
This DC Splitter will work only with FSN Medical
Technologies display monitors, and has been tested
to have no effect on the performance of either the
display or the W-hDM3D-S-100 receiver.
