10
INSTALLATION
These systems are designed with embedded directional antennas and aim out of the
front face of the enclosure. It is important for both antennas to be “looking at each other”
and ideally mounted at the same approximate height from the ground. We recommend
a mounting height no less than 15 feet above any obstruction.
Wall Mounting
Fasten the base plate of the
mounting brackets to the wall using
four screws or bolts (not included).
Ensure the mount is secure and
capable of supporting the weight of
the transmitter or receiver.
See Step 2
Pole Mounting
Fasten the base plate of the
mounting brackets to the pole
with the included hose clamps.
See step 2
Attach the pivot plate (of the mounting brackets) to the
base plate using four mounting screws –
Included
Insert and secure the four mounting screws into each
corner of the IP-67 enclosure. Ensure the grommet
seal plugs a point down to avoid water damage and
void the warranty.
Replace the front cover of the transmitter or receiver.
Do not over tighten the screws as this can crack or
cause damage to the front cover of the unit. Verify all
cable glands are snug, and have a water tight seal.
Adjust the angle of both the transmitter and receiver to
ensure proper alignment and secure in place using the
included mounting screws.
