12
6. WIRED REMOTE CONTROL
If the VCR-322 Plus is located in a place inaccessible by IR remote then you may have to
build and connect a wired remote to your VCR or can purchase Rm-322 wired remote. To do
this you will have to wire the 4 programming buttons shown below to the DB 25 connector on
the rear of the VCR. To access the VCR function remotely you must purchase an FR-9 PCB
from from AVE and wire buttons to the PCB and use the 2 wire IR in connection. You may
also build a wired remote with all VCR-322 features using the following equipments from a
local electronics distributor.
• Momentary push buttons
• Electronics enclosure
• 4- light emitting diodes
• 4 1K 1/4 watt resistors
• DB 25 connector
4 buttons are necessary to access the on-screen programming menu of the VCR-322,
and must be wired according to the following diagram.
Pin 18-Down
Pin 16-Up
Pin 20-Set
Pin 15-Reset
Reset
Set
Up
Down
Ground-use Pins 10, 11, 12, or 13, whichever is available
These 3 buttons are optional
Alarm Record
Message 2
Message 1
Pin 9-Alarm Record
Pin 22-Message 2
Pin 25-Message 1
Ground-use Pins 10, 11, 12, or 13
The 4 Mode LED Indicators are optional
Pin 1-Record
Pin 7-End of Tape
Pin 5-Low Tape
Pin 3-Power
End of Tape
Low Tape
Power
Record
Anode side of LEDs to +12V Pin 23
Programming Buttons
momentary
pushbuttons
momentary
pushbuttons
1K
1K
1K
1K
Содержание VCR 322 PLUS
Страница 1: ...VCR 322 PLUS MOBILE VIDEO CASSETTE RECORDER VHS OPERATION MANUAL NTSC PAL ...
Страница 2: ......
Страница 4: ......
Страница 35: ...35 ...