7
18). AUX SEND:
This is a master control that adjusts the output signal level at the
AUX SEND (12)
jack.
19). AUX RETURN Control:
The left and right return signals will be routed to the Aux Return level control and mixed into the left and
right
Stereo Out (13)
, while maintaining stereo separation.
20). PHONES/CONTROL ROOM CONTROL
:
The mixer allows you to monitor the Master Mix. The signal level is adjusted with the Phones/Control
Room control and routed to both the
Control Room (16)
and
Headphones (17)
outputs.
21). LED OUTPUT METER
:
The 10-stage LED Output Meter displays the Master Mix output level.
22) PHANTOM POWER ON/OFF SWITCH
When using condenser MICs, +48VDC can be switched globally on or off to the XLR MIC inputs for all
mono channels. When this switch is in the “ON” position, The
Phantom Power On LED Indicator (25)
will light, and +48VDC will be provided between pins 2 and 3 on all the mono MIC input XLR connectors.
If you don’t need phantom power, be sure to turn this switch to the “OFF” position.
Note: It is safe to connect balanced dynamic MICs or line level devices even if this switch is on, but
connecting unbalanced devices or devices whose transformers are center-grounded will cause hum or
malfunctions. Shorting the +48VDC can also damage your mixer. Also, mute the Monitor/PA speakers
when turning the phantom power on or off.
23). TAPE/REC TO CONTROL ROOM SWITCH
:
Use the Tape/Rec to Control Room switch to route signals from the
Tape Input (14)
to the
Phones/Control Room control (20)
.
