AVE Allumia 443016S Series, Руководство по эксплуатации

Страница: 34 / 115

ENGLISH 32
PROGRAMMING
1 Programming pushbutton
The P1 pushbutton can be used to program the device, and is accessible using a straight
screwdriver, via the slot specifically provided on the side of the device itself (see Fig. 1).
1.1 Programming
Programming is accessed by holding down the P1 pushbutton on the side for 4 seconds.
Confirmation of programming mode is provided by the buzzer, and the cyclical “circular” switching on and
off of the red perimeter LEDs clockwise, for 5 seconds.
The programming sequence includes 3 steps, which are described below in the order in which they are
presented. As confirmation, the built-in buzzer emits a number of beeps that corresponds to the
programming step number. You can go from one step to the next by pushing P1 briefly. To exit
programming, hold the P1 pushbutton on the side down for 4 seconds again. Programming is also exited
after a 2 minute time-out.
Fig 1