Avdel Genesis G1, Инструкция по эксплуатации

Страница: 20 / 92

20
F a u l t D i a g n o s i s
S Y M P T O M P O S S I B L E C A U S E R E M E D Y PA G E R E F
More than one Air leak Tighten joints or replace components
operation of the Insufficient air pressure Adjust air pressure to within specification 5
trigger needed to Lack of lubrication Lubricate tool at air inlet point 7
place fastener Worn or broken jaws Fit new jaws 8-9
Low oil level or air in oil Prime tool 18-19
Build up of dirt inside the nose assembly Service nose assembly 8
Tool will not grip Worn or broken jaws Fit new jaws 8-9
stem of fastener Build up of dirt inside nose assembly Service nose assembly 8
Loose jaw housing Tighten against locking ring 8-9
Weak or broken spring in nose assembly Fit new spring 8-9
Incorrect component in nose assembly Identify and replace 8-9
Rotary valve incorrectly adjusted Adjust as in ‘Operating Procedure’ 7
Jaws will not release Build up of dirt inside the nose assembly Service nose assembly 8
broken stem of Jaw housing, nose tip or nose
fastener casing not properly seated Tighten nose assembly 8-9
Weak or broken spring in nose assembly Fit new spring 8-9
Air or oil leak Tighten joints or replace components
Low oil level or air present in oil Prime tool 18-19
Cannot feed next Broken stems jammed inside tool Empty stem collector 4 (point 14)
fastener Check jaw spreader is correct 8-9
Adjust air pressure to within specification 5
Rotary valve incorrectly adjusted Adjust as in ‘Operating Procedure’ 7
Slow cycle Lack of lubrication Lubricate tool at air inlet point 8
Low air pressure Adjust air pressure to within specification 5
Build up of dirt inside nose assembly Service nose assembly 8
Tool fails to operate No air pressure Connect and adjust to within specification 5
Damaged trigger valve 41 Replace 16-17
Loose base cap 35 Tighten 16-17
Loose stem collector Tighten retaining nut 21 16-17
Fastener fails to break Insufficient air pressure Adjust air pressure to within specification 5
Fastener outside tool capability Use more powerful Genesis tool.
Contact Avdel UK Limited
Low oil level or air present in oil Prime tool 18-19
Item numbers in bold refer to the general assembly drawing and parts list on pages 16-17
Other symptoms or failures should be reported to your local Avdel authorised distributor or repair centre.