Avdel Genesis G1, Инструкция по эксплуатации

Страница: 11 / 92

11
S e r v i c i n g t h e To o l
E n g l i s h
•
Daily, before use or when first putting the tool into service, pour a few drops of clean, light lubricating oil into the air inlet of the tool
if no lubricator is fitted on air supply. If the tool is in continuous use, the air hose should be disconnected from the main air supply
and the tool lubricated every two to three hours.
•
Check for air leaks. If damaged, hoses and couplings should be replaced.
•
If there is no filter on the pressure regulator, bleed the air line to clear it of accumulated dirt or water before connecting the air
hose to the tool. If there is a filter, drain it.
•
Check that the nose equipment is correct for the fastener to be placed.
•
Check the stroke of the tool meets the minimum specification (page 5). The last step of the Priming Procedure on page 19 explains
how to measure the stroke.
•
Either a stem collector or a stem deflector must be fitted.
•
Check that base cover 35 is fully tightened onto body 33 . Check that broken stems are being extracted to the rear of the tool. If
not, refer to ‘Adjusting the vacuum extraction’ page 8.
•
Using a screwdriver turn rotary valve 57 until the air flow at the rear of the tool ceases. With the nose of the tool pointing
downwards, insert a fastener into the nose and hold it into position. Turn the rotary valve either way until there is sufficient suction
to retain the fastener.
•
Dismantle and clean nose assembly, with special attention to the jaws. Lubricate with Moly Lithium grease EP 3753 before
assembling.
•
Check for oil leaks and air leaks in the air supply hose and fittings.
Grease can be ordered as a single item, the part number is shown in the service kit page 13.
First Aid
SKIN:
As the grease is completely water resistant it is best removed with an approved emulsifying skin cleaner.
INGESTION:
Ensure the individual drinks 30ml Milk of Magnesia, preferably in a cup of milk.
EYES:
Irritant but not harmful. Irrigate with water and seek medical attention.
Fire
FLASH POINT: Above 220°C.
Not classified as flammable.
Suitable extinguishing media: CO
2
,
Halon or water spray if applied by an experienced operator.
Environment
Scrape up for burning or disposal on approved site.
Handling
Use barrier cream or oil resistant gloves
Storage
Away from heat and oxidising agent.
Item numbers in bold refer to the general assembly drawing and parts list on pages 16-17.
D a i l y
I M P O R T A N T
Read Safety Instructions on page 4.
The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate personnel.
The operator should not be involved in maintenance or repair of the tool unless properly trained.
The tool shall be examined regularly for damage and malfunction.
We e k l y
M o l y L i t h i u m G r e a s e E P 3 7 5 3 S a f e t y D a t a
•
Check and replace Plastic Body and Base Cover if there is evidence of impact damage, chipping or cracks.
M o n t h l y