Avdel 74405, Инструкция по эксплуатации

Страница: 14 / 28

14
A i r M o t o r A s s e m b l y
H a n d l e a n d Tr i g g e r A s s e m b l y
M a i n t e n a n c e
•
Tap the Air Motor Casing 3 gently on the bench to remove the air motor assembly from the casing.
•
Using circlip pliers*, remove Circlip 14.
•
Remove Bearing 15 and Planet Gear Spindle 11, together with three Planets 16 from Planet Gear 10.
•
Remove Planet Gear 10 and Spacer 17.
•
Using a soft mallet, tap on splined head of Rotor 19 and remove Bearing 9 and Front End Plate 8.
•
Tap out Rotor 19 and Rotor Blades 7, five off.
•
Place Rear End Plate 20 in the vice and using a pin punch*, tap on centre of Rotor 19 to remove Bearing 21.
Take care not to lose Pin 6.
•
Remove Bearing 21.
•
Assemble in reverse order of dismantling, observing the following:
•
Rear side of Rotor 19 must touch Rear End Plate 20 without any axial gap. Any existing gap will disappear when Bearing 21 is fully
located.
•
When inserting the air motor assembly into Air Motor Casing 3, align components so that Pin 6 locates the centre hole between the
spin-on and spin-off ports of the air motor casing.
•
Using a spanner, undo Lock Nut 35 and remove Trigger 34, ‘O’ Ring 36 and Spring 2 from Handle 28.
•
Remove Screw 41 to release Emergency Spin-Off Button 40.
•
Assemble in reverse order to dismantling.
*refers to items included in the 74405 Service Kit. For a complete list see page 11.
Item numbers in bold refer to the Base Tool General Assembly drawing and Parts List pages 16-17.