Avaya IP Office H.323, Руководство по установке

Страница: 49 / 104

H.323 Telephone Installation Page 49
15-601046 Issue 17e (Wednesday, November 14, 2012) IP Office
Installation: Phone Connection
2.7 Static Address Installation
Static addressing is only necessary when a DHCP server is unavailable or not desired. For ease of maintenance and
installation, it is strongly recommended that a DHCP server used and that static addressing is avoided. Following any
boot file upgrade of the phone's firmware, static address information may require reinstallation.
The use of static address installation is not supported with 4601 and 5601 phones.
1600, 4600 and 5600 Series Phones
1. Follow the steps in Phone Connection until DHCP is shown on the phone display. Press * at this point to switch
the phone to static address installation. Existing 4600 and 5600 Series phones can be made to start static address
installation while idle by pressing MUTE 2 3 3 7 # (MUTE A D D R #).
2. The phone will display a sequence of settings and the existing value for each of those settings. To accept the
current value, press # or enter a value and then press #.
3. While entering data in the following actions it may sometimes be necessary to backspace. The method for doing
this varies according to the phone type:
·
4602, 5602: Speaker key.
·
4606: Conference key.
·
4612 & 4624: Previous key.
·
4610, 4620, 4625, 5610, 5620: Left-most key.
4. The settings shown for static address installation are:
·
Phone =
This is the phone's IP address. To accept the current value, press # or enter a value and then press #. If
entering a new value, press the * key to enter a '.' character between digits.
·
CallSv =
This is the address of the H.323 gatekeeper. For IP Office systems this is the IP address of the IP Office LAN.
·
CallSvPort =
This is the Gatekeeper transport layer port number. For Avaya IP phones the value used should be 1719. To
accept the current value, press # or enter a value and then press #.
·
Router =
This is the address of the phone's default IP gateway. For IP Office this is typically the IP address of the IP
Office LAN. To accept the current value, press # or enter a value and then press #.
·
Mask =
This is the phone's IP Mask (also called the subnet mask). The mask is used with the IP address to indicate
the phone's subnet. This should match the IP mask set for the IP Office Unit.
·
FileSv =
This is the address of the file server from which the phone should request software and settings files. Enter
the address of the TFTP or HTTP configured with the Avaya IP phone software file set.
· 802.1Q =
To change the setting press *. Press # to accept the value.
· VLAN ID =
For details of VLAN configuration see
VLAN and IP Phones .
5. If you go through without changing anything, the phone displays No new values. Press #. If the phone displays
Enter command, power off and on again.
6. Once all the values have been entered or the existing values accepted the phone will display Save new values?.
To save the values, press #. The phone will save the values and then restart using those values.
7. The phone registration menu is displayed.
48
59
51