6
Note:
For wall installation, do NOT unbundle the line cord
packaged with the telephone; that is, leave the line cord in its
coiled position.
1
You must reverse the handset tab (which holds the
handset when you hang up). See Figure 4.
■
Hold down the switchhook and slide the handset tab up
and out of its slot.
■
Turn the tab so that the curved end is facing up.
■
Insert the tab back into its slot.
Figure 5. Reversing the Handset Hook
2
Turn the telephone upside down so that you can see the
bottom of the telephone.
3
Remove the mounting base by sliding the base to the left
until it is free of the telephone. See Figure 4.
4
Turn the base so the larger end is down.
5
Plug one end of the line cord into the line jack on the
bottom of the telephone. (Keep the cord bundle in the
cavity on the lower housing.) Leave the other end of the
cord unattached for later use.
Note:
You may prefer to use an 8-inch line cord rather
than the 14-foot cord provided with the telephone. If you
use the 14-foot cord, you will need to place it into the
back of the telephone in its original coiled position.
6
After you have attached the stand to the telephone, use
the screw provided to tighten the stand onto the back of
the telephone set.
Figure 6. Tightening the Stand to Back of the Telephone
a. Handset
b. Press to release
d. Replace handset
c. Reposition
retainer
in place
and then remove
handset retainer
handset
retainer
down
retainer
(down
(up
position)
position)
230709i3.fm Page 6 Thursday, February 27, 2003 2:28 PM
