5
2
Remove the desk stand by sliding it to the left until it is
free of the telephone base.
Figure 3. Sliding the Base from the Bottom of the Set
3
Plug one end of the line cord into the line jack on the
bottom of the telephone.
4
Align the other end of the line cord so that it appears
through the slot at the top of the stand and reattach the
stand to the telephone by sliding the stand into the
appropriate tabs and then to the right.
5
After you have attached the stand to the telephone, use
the screw provided to tighten the stand onto the back of
the telephone set.
Figure 4. Tightening the Stand to Back of the Telephone
6
Turn the telephone right-side up and place it on your desk
or table.
7
Plug one end of the coiled handset cord into the handset
jack on the side of the telephone.
8
Plug the other end of the handset cord into the handset.
9
Hang up the handset.
10
Plug the free end of the line cord into a modular wall jack.
11
Lift the handset and listen for dial tone.
12
Set the Ringer Volume Control switch to the setting you
want.
WALL INSTALLATION
Use the following directions to mount the telephone on a
standard wallphone jack with mounting studs.
Slide stand
to left and lift
Desktop
stand
230709i3.fm Page 5 Thursday, February 27, 2003 2:28 PM
