Avaya 700457013, Инструкция по эксплуатации

Страница: 3 / 14

Inserting or replacing a RAM card
03-603203 Issue 1 May 2009 3
Removing the G450 main board
ELECTROSTATIC ALERT:
ELECTROSTATIC ALERT:
Hold the module only by its edges to avoid damage from static electricity. Do not
touch the top or bottom of the circuit board. If possible, wear a wrist-strap and use
an anti-static bag.
!
CAUTION:
CAUTION:
The connector pins can be bent or damaged if the module is handled roughly, or if
misaligned and then forced into position.
1. Unscrew the two captive screws, one at each side of the main board front panel (see
Figure 1 ).
2. Open the latches on both sides of the main board.
3. Grasp the latches and pull out the main board from its slot.
4. Place the main board carefully on a flat surface.
Figure 1: Removing and inserting the main board
Inserting a G450 1.x RAM card
ELECTROSTATIC ALERT:
ELECTROSTATIC ALERT:
Hold the module only by its edges to avoid damage from static electricity. Do not
touch the top or bottom of the circuit board. If possible, wear a wrist-strap and use
an anti-static bag.
1. Locate the empty RAM slot (see Figure 2 ).
2. Make sure the white latches at either side of the empty RAM slot are open outwards.
3. Insert the 256 MB RAM card provided in the kit into the RAM slot and push down, until the
two latches on either side of the card lock into place.