Avari Fitness AVARI Easy Glide Rower, Руководство пользователя

Страница: 14 / 22

14
The safety and integrity designed into the AVARI® Easy Glide Rower can only be maintained when the
AVARI® Easy Glide Rower is regularly examined for damage and wear. Special attention should be
given to the following:
1. Pull on the HANDLEBAR(9) and verify that the SHOCK(42) provides tension.
2. Clean the roller tracks in the CENTER BEAM(1) with an absorbent cloth.
3. Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts.
Tighten loose nuts and bolts.
4. Verify that the CAUTION LABEL(70) is in place and easy to read. Call Stamina Products immediately
at
1-800-375-7520
for a replacement
CAUTION LABEL(70)
if it is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the AVARI® Easy Glide Rower
removed from service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the AVARI® Easy Glide
Rower.
8. Keep your AVARI® Easy Glide Rower clean by wiping it off with an absorbent cloth after use.
9. Check the condition of the ROPE(51). Replace the ROPE(51) if it is cracked or broken.
MAINTENANCE
ROPE ADJUSTMENT
Over time your
ROPE(51)
may stretch. If the
ROPE(51)
doesn’t retract fully into the
UPRIGHT(3)
and the
HANDLEBAR(9) doesn’t stay on the HANDLEBAR HOLDER(50), make this adjustment. Remove the
HANDLEBAR COVER(52) by unscrewing the SCREWS(M4x15mm)(49). Loosen the BOLTS(M6x1x20mm)
(64),
but do not remove them. Pull the
ROPE(51)
until there is a 3/8 inch of gap on the shaft of the
SHOCK(42),
refer to illustration A. Then entwine the ROPE(51) around the BOLTS(M6x1x20mm)(64) using a figure eight
pattern and tighten the bolts so the ARC WASHERS(M6)(65) press against and secure the ROPE(51) in
position. Re-attach the HANDLEBAR COVER(52) with the SCREWS(M4x15mm)(49).
Gap
A.