- 7 -
User Manual
Startup
- Temperature control set at No . 4 position gives refrigerators an approximate temperature of 35°F .
Allow unit to function several hours, completely cooling cabinet before changing the
control setting .
- Excessive tampering with the control could lead to service difficulties . Should it ever become
necessary to replace temperature control, be sure it is ordered from your Avantco dealer or
recommended service agent .
- Good air flow in your unit is critical . Be careful to load product so that it neither presses against
the back wall, nor comes within four inches of the evaporator housing . Refrigerated air off the coil
must circulate down the back wall .
Recommendation:
Before loading product, we recommend you run your Avantco unit empty for 2-3 days . This allows
you to be sure the electrical wiring and installation are correct and no shipping damage has
occurred . Remember, the Avantco factory warranty
does not
cover product loss!
set
mute
Dial Controls
Digital Controls
Temperature Setting
Dial Controls (UDD1 & UDD1S ONLY)
Temperature range from (7) Coldest to (1) Warmest
Digital Controls (All Other Models)
Refrigerators are programmed to operate between 33 and 40°F
To set the temperature you would like your unit to run at:
1 . Hold “SET” for 1 sec . The display will flash the temperature
that the refrigerator is currently set to .
2 . Use the arrow buttons to adjust the temperature .
3 . Press “SET” to save your settings .
If the unit consistently runs 5+ degrees higher than your set
temperature, service may be needed .
Note: All other control functions should only be performed
by a trained service technician.
Drain Instructions
On direct draws, the drain is located at the front of the cabinet .
(UDD1 & UDD1S drain into a bottle located inside the unit)
To plumb in the drain, connect ½” PVC pipe to the barbed fitting supplied with the unit .
If you would prefer to drain the beer inside the unit (for mobility or where a drain can’t be found):
- Use a screwdriver to remove the drain bracket .
- Pull the drain hose so that it is inside the unit .
- Attach a bottle to the drain hose inside the unit .
- Plug the created hole at the bottom of the unit
