User Manual
www.AvantcoEquipment.com 3
!
!
!
!
!
!
WARNING
• DO NOT store gasoline or other flammable liquids in the vicinity of this or any other appliance.
• Improper installation, adjustment, alteration, service or maintenance can cause property damage, injury or
death. Read the installation, operation and maintenance instructions thoroughly before installing or servicing
this equipment.
IF YOU SMELL GAS
• DO NOT try to light any appliance.
• DO NOT touch any electrical switch.
• DO NOT use any telephone in your building.
• In the event a gas odor is detected, shut down the unit at the main gas shut-off valve and contact your local
gas supplier from a neighboring location. Follow the instructions received from the gas supplier immediately
and exactly.
WARNING: FIRE HAZARD
• The area where the appliance is installed must be kept clear of combustibles and flammables.
This includes mops, rags, grease, wrapping paper and electrical cords.
• This appliance is designed for use in non-combustible locations only. Install the appliance on a firm, level,
non-combustible surface.
• Maintain adequate clearances for cleaning and proper operation. This unit must be installed in an area with
sufficient make-up air for proper combustion, and must be installed such that the flow of combustion and
ventilation air will not be obstructed. For servicing, a clearance of 6 inches (15cm) from rear of the appliance to
wall should be kept.
WARNING: ELECTRICAL GROUNDING HAZARD
• This appliance is equipped with a three-prong (grounding) plug for your protection against shock hazard and
should be plugged directly into a properly grounded three-prong receptacle.
• DO NOT cut or remove the grounding prong from this plug.
• All the operators should abide by the local electricity standards. Verify the locally available current. It should be
in conformity with the rating voltage on the serial plate and make sure that the appliance is grounded safely.
DANGER: HEALTH HAZARD
• This appliance must be properly ventilated. Failure to provide and maintain proper ventilation of exhaust
gases can result in severe injury or death.
DANGER: FIRE & EXPLOSION HAZARD
• DO NOT use an open flame to check for gas leaks. Fire and explosion may result.
• Use pipe sealant made specifically for gas piping on all pipe joints. Sealant must be resistant to the action of
different gases.
• Verify that all supply piping is clean and free of obstructions, dirt, chips and pipe sealant compound prior to
installation.
• All pipe joints should be checked for leaks before lighting. Leak checks should be performed with a soap and
water solution. Never check for leaks with an open flame.
• Verify fuel gas type. If the available fuel doses not match the nameplate specification, call for a qualified
technician to exchange the part.
Important Safeguards
