AVANT A36015, Руководство оператора

Страница: 22 / 30

22 (30)
6.6 Preventing and clearing blockages
Keeping the rotating speed sufficiently high and drive speed low on demanding conditions are essential to
avoid blockages. Keep the equipment clean, so that material will not stick on it.
Wet, thick and log grass can get coiled around the flail shaft if drive speed is too high. When mowing high or
wet hay more than one run may be needed for even results. Also, adjusting the cutting height to higher
setting, or operating at lifted operating position, will help avoiding blockages.
If blockage occurs, it needs to be cleared manually using suitable tools. Follow safe stopping procedure
before going near the mower.
DANGER
Cutting hazard - Unexpected starting. Clearing a blockage can start the mower
unexpectedly immediately after clearing the blockage, if the auxiliary hydraulics of the
loader is left on.
Always stop the loader by following the safe stopping procedure before going near the
mower. Never reach to the cutting deck if the mower or its blades can move.
To prevent accidents, turn the auxiliary hydraulics control lever of the loader to its neutral
position, shut down the loader engine and release the residual pressure always before
going near the attachment.
DANGER
Risk of serious personal injuries - Unexpected starting. To make sure that the
attachment will not rotate, disconnect the multiconnector (or hydraulic quick couplings)
before going near it.
.