Avani SPC-230, Руководство пользователя

Страница: 6 / 66

SPC-230
AVANI Welding Fume Extractor
Page-6
7. Check that the voltage, phase count and grounding wire match the machine
requirements.
8. When the fan blades are operated at high speed, do
not reach hand near these blades to prevent
finger from breaking or clothes/necktie from getting caught. Do not put the hand
or foreign matter into the air inlet to avoid getting caught in the high-speed
rotation of fan blades.
9.
When not in use, all air inlets of Welding Smoke Treatment Machine shall be
covered.
Assembly
Do not connect the Welding Smoke Treatment Machine before the assembly
is finished and you have read and understood all of the precautions stated
in the Manual.
NOTE: For correct assembly, refer to the Illustrations and Parts List on pages 11-15.
Installation
MOVING AND TRANSPORTATION
The net weight of this machine is about 64 lbs. It CAN be handled and transported
without the help of lifting tools. For your safety, read all instructions carefully.
Do not move without the help of others to avoid causing danger.
ELECTRICAL INSTALLATION
POWER CONNECTION
1.
Confirm that the power is properly connected under normal power supply condition.
It is recommended to provide manual shutdown device before connecting power.
SHUTDOWN
1.
Disconnect power by manual method.
2. When stopping operation, check if the switch is under off status.
Grounding Wire
Connect yellow/green wires to the grounding wire power jack. Confirm that the ground
wire has been properly connected before connecting main power cord to the machine
at all times.
Do not disconnect the wiring jack before cutting off
power!
POWER INSTALLATION AND STORAGE