Continuous Feed
Always use caution when handling blades and discs.
It is recommended to use cut resistant gloves while handling
the blade or cutting discs.
ASSEMBLY INSTRUCTIONS
3.
1.
Ensure the machine is unplugged.
2.
Continuous Feed attachment ships assembled
with pusher, ejection disc, slicing disc and grating
disc included.
3.
Place the continuous feed attachment angled on
the base as shown in figure 1B. Twist the
attachment into place by twisting it
counterclockwise. It will lock in place with the
exit chute straight over the front of the unit.
See Figure 2B.
4.
Open the Continuous feed attachment by
unhooking the latch (figure 3B).
5.
You now have access to switch out the cutting discs.
Caution: Blades are very sharp.
Never touch blades directly.
6.
The motor shaft has a pin which is used to lock in
the plates for continuous feed model. The bottom
pin is used to hold the plastic ejector in place.
See figure 4B
7.
When removing or adding a plate to the motor
shaft- ensure that the bottom end which end which
locks into the pins is facing down. See figure 5B.
8.
To remove a plate- you must twist the plate
counterclockwise until it clears the pins and then
gently lift up. See Figure 6B.
9.
To add a plate- Line up the openings with the
pins on the motor shaft, lower in to place and twist
clockwise to lock in place. See figure 7B.
10.
Once plates are in place. Close the lid and use the
latch to shut the lid. See figure 8B.
11.
Do not operate this machine if any damage is noted
to the cutting discs, food processor or continuous
feed attachments.
FIG. 1B
FIG. 3B
FIG. 5B
FIG. 7B
FIG. 2B
FIG. 4B
FIG. 6B
FIG. 8B
