Technical Specifications:
(typical)
Characteristic
Specification - description
RF transmission rate:
1.5 Mb/s
Throughput:
935 Kb/s
Output power:
+21dBm – (4 Watts EIRP with 15dBi antennae)
Receive sensitivity:
-97dBm at 10e-4 BER (-112dBm with 15dBi antennae)
Latency:
< 2ms – assuming a dedicated wireless link to client device.
Jitter:
±0.5ms – depending upon packet size, interference and SNR.
Voltage Range:
AW-900x
AW-D900
9-48VDC
24VAC
Power Consumption:
AW-900x
AW-D900
TX 1.3Watts and RX 0.6Watts over 9-48VDC input voltage.
55Watts (including 20 watt heater)
Radio channels:
12 Non-overlapping
Automatic frequency select:
Yes – radio channel automatically selected and adaptively optimized
Manual frequency mode:
Yes
Status LEDs:
Power, RF Link, Ethernet Link, Traffic, RF RX, RF TX, 4/Channel and
6/Link Quality
Error correction technique:
Sub-block error detection and retransmission
Adjacent-band rejection:
SAW receiver filter attenuates cellular and pager interference.
Temperature range:
AW-900x
AW-D900
-40°C to 70°C
-30°C to 50°C - Depends upon temp range of Camera
Heater turn on at 10°C off at 27°C, Blower on at 45°C off at 27°C
Power over Ethernet:
Use with 9VDC to 48VDC POE systems with lines 4/5 positive, 7/8 ground.
Product limited warranty:
This product is warranted to the original purchaser for normal use for a period of 180 days from the date
of purchase. If a defect covered under this warranty occurs Avalan will repair or replace the defective
part, at its option, at no cost. This warranty does not cover defects resulting from misuse or modification
of the product.
Compliance Statement ( Part 15.19 )
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Warning ( Part 15.21 )
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
RF Exposure ( OET Bulletin 65 )
To comply with FCC RF exposure requirements for mobile transmitting devices, this transmitter should only be used or installed at
locations where there is at least 20cm separation distance between the antenna and all persons.
Information to the User - Part 15.105 (b)
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
