4.4 Instructions for Use
Chapter - 4
SAFETY
FIRST
4.4 Instructions for Use
•
Do not place the CR OR series in an environment where moisture, dust,
corrosion, extreme cold and heat (exceeding the temperature of the parts), as this
environment can cause LED damage or discoloration on the module.
•
CR OR series products can not be used in the lampblack-abundant
environment, because the use of such environment will cause a layer of greasy
residue on the surface of the module, which is difficult to remove.
•
CR OR series products can not be placed in an environment with no
ventilation and near the high heat source (such as laser irradiation environment,
beside the stove).
•
The voltage and power of the power supply equipment of the CR OR series
must meet the requirements.
•
When the CR OR series products are not used for a long time, please cut off
the power supply to avoid a safety accident.
•
When installing or disassembling the CR OR series products, pay attention to
the corners of the cabinet, do not be impacted, remove or install the protective
angle of the cabinet in time, and place the anti-static carpet on the ground of the
cabinet. Anti-damage module or lamp surface.
•
The power cables and signal cables between the cabinets are not allowed to be
hang with anything.
•
CR OR Series modules should not be used near any device other than CE certified.
•
When reconnecting the power and signal cables, ensure that the cables are
connected according to the installation manual to prevent damage to the cables
or other components.
•
The air suction tool is used to disassemble the module. The method of use must
conform to the specifications.
•
When using the rolling mask tool, the action should be light to avoid damage to
the module.
•
CR OR series products are limited to vertical installation: hanging and
stacking, 16 cabinets max to hang and 20 cabinets max to stack.
•
For small-pitch products, it is easy to be damaged and easily damaged.
process of using, you need to wear anti-static gloves and handle them with care.
