5.
9. Once the label has been pulled through the
outside of the printer, take the end of the
label roll and run the labels on the left side
and out the right side of the final black spool
in the middle of the printer. (Fig. 12) Once the
label roll has been inserted as shown below,
manually spin the spool clockwise to begin
wrapping the labels around the spool.
10. Once these steps have been completed,
this is what the printer should look like if
everything is completed correctly. (Fig. 13)
NOTE:
Before printing remember to re-
engage the printer lock. (Fig. 13A) If this is not
completed, you will get a notice when trying
to print on the scale indicator.
NOTE:
If you get a “No Paper” error once you
print, it’s because you have the paper on the
outside of the two orange guards from step 7.
The paper must be put in the middle.
FIG. 12
FIG. 13
FIG. 14
FIG. 15
FIG. 16
A
LABEL PAPER
The AvaWeigh scales use Thermal Seam Marking
Label paper.
• Height: 60 mm
• Width: 30-60 mm
• Max. Outside Diameter: 100 mm
• Min. Inner Diameter:
26.8 mm (Fig. 14) or 40 mm (Fig. 15)
• Match inner diameter to corresponding roll
mandrel (Fig. 16)
