1. Locate the printer panel on the right side of
the scale if you are looking at the face of the
scale. (Fig. 6)
2. Pull down on the top of the panel to expose
the printer. (Fig. 7A)
3. Once the panel has been opened, grab the
handle on the inside of the printer and pull
outward to expose the entire printer. (Fig. 7B)
4. Locate your label roll and remove 3-4 labels
from the end of the roll to give yourself slack
to install the labels into the printer.
• Roll Width: 30-60 mm
• Outer Diameter: 100 mm
• Inner Diameter: 40 mm
5. Once 3-4 labels have been removed from the
end of the label roll, place the label roll on
the black three-pronged spool located on the
right side of the printer. (Fig. 8)
6. Once the labels have been loaded onto the
black spool (Fig. 9A), pull the end of the label
roll around the white spool (Fig. 9B) so they
are in between the scale body and the spool.
7. Next, pull the end of the label roll in between
the two orange guards. (Fig. 10A)
NOTE:
The printer lock must be disengaged
and in a horizontal position. If the printer lock
is still engaged, turn the top counterclockwise
to disengage the lock and open the exit for
the label to pass through. Once this step is
complete, the label should be sitting just at
the end of the exit.
8. Next, proceed to pull the end of the label roll
through the label exit, (Fig. 11) and push it
back through the other side so that the labels
wrap around the outside of the printer.
4.
FIG. 6
FIG. 9
FIG. 11
FIG. 10
FIG. 7
FIG. 8
INSTALLING THE THERMAL LABEL PAPER
Continued on Next Page
A
A
A
B
B
B
