Help: 888-426-5001
QualityWaterForLess.com
3) Before filling the tank, place a piece of painter's
tape over the top of the riser to prevent resin
from dropping down inside the riser tube as
shown in
figure 7-A.
i
Avoid using duct tape
which leaves behind unwanted residue
4) Place the included filling funnel over the top of
the tank as shown in
figure 7-B
and prepare to
fill the tank. If your softener system came with
gravel
, please pour this into the tank
first
, then
pour in the included resin media afterwards
F I G u R e 7- a
F I G u R e 7- B
s ta n d a R d
F I n e m e s H
3 ›I n s ta l l I n G t H e au tot Ro l 2 5 5 / 76 0 Va lV e
1) Remove the filling funnel and tape and while
using the included silicone lubricant packet, lubri-
cate the inner and outer o-rings on the bottom of
the Autotrol 255/760 Valve as shown in Figures
7-C and 7-D
2) Next, install the
top screen (standard OR fine
mesh)
to the bottom of the Autotrol 255/760 Valve
as seen in Figure 7-E (you may need to strip the
groove tabs with a razor before attaching). Then
place the valve onto the top of the tank, being sure
that the riser tube fits into the central o-ring on the
valve, as shown in Figure 7-F.
hand-tighten
the
valve to the tank.
do not use Teflon tape or pipe
dope on the valve or tank threading
F I G u R e 7- C
F I G u R e 7- e
F I G u R e 7- d
F I G u R e 7- F
